Skip to main content
Configuration Guide (Global)

Once your installation is complete, use Verdigris Setup Tools to complete the configuration.

Updated over a week ago

Once your Verdigris system is installed, the Configuration step is required to ensure the metered data is transmitted to the cloud.

  • Ensure the system is power on and the Light Indicators on the Energy Gateway are all turned green. If any of the light indicators are NOT green, check out our Error Codes guide

  • Contact your Verdigris Account Executive to complete the configuration

  • Check out the Update your Building Profile article to verify your address and building details

After setting up a few simple steps, you can now start viewing your Building's Energy Data!

Did this answer your question?